crestron xpanel stuck on loading interface

To enable XPanel connection navigate to Settings tab in DMPS device web page, enable the ‘Allow XPanel Connection’ toggle button then click on ‘Save Changes’. After factory restore in release 2.1 XPanel connection to DMPS will be disabled. To remove the HTML5 Web XPanel functionality from your CH5 project, set the useWebXPanel property to false in the project‑config.json file. It is recommended to uninstall XPanel from Desktop before installing it from DMPS. This can be useful when using the npm run start command. ' would use host “W.X.Y.Z” and IPID 0x0A.'' would use default host “W.X.Y.Z” and IPID 0x0A.'' would use all default values including host “W.X.Y.Z” and IPID 0x03.The following examples assume that no parameters are provided in the project-config.json file: The order of precedence is 1.) URL parameter, 2.) project-config.json parameter, and 3.) the defaults described earlier. tokenSource and tokenUrl should not be changed, as they are provided to ensure forward compatibility with future identity provider services.Ĭhange XPanel Connection Parameters via URLĪll the parameters described in prior sections ( host, ipId, roomId, port, and licenseExpirationWarning) can be provided as URL parameters to allow a single project to be used for multiple systems with different parameters.port: Change only if the control system SECUREWEBSocketport parameter was changed from its default value or a port forwarding rules are in effect.Set to '0' to disable the expiration warning message. Use this parameter to change the number of days before this warning is shown. licenseExpirationWarning: A warning message can be shown a set number of days before a Mobility license or a license trial period will expire.This parameter is applicable only for VC-4 deployments. The default value is the Room ID in the Web XPanel URL provided by VC-4 (/VirtualControl//XPanel). roomId: The Crestron Virtual Control (VC-4) Room ID.ipId: The IP ID of the control system program.The default value is the same domain as the Web XPanel URL.

It can be provided as a host name, FQDN (fully qualified domain name), or an IP address.

Refer to Change XPanel Connection Parameters via URL. NOTE: The parameters provided in the config/controlSystem object will be overwritten when the same parameter is proved as a URL parameter.

Crestron xpanel stuck on loading interface